What have you done to your rig today?
- Thread starter HoneyBadger
- Start date
74fj40
Hard Core 4+
Nice work ken, that’s a cool upgrade. Do you have the part numbers handy?
Remember mine isnt a stock setup. You can find the cap in the other parts at the bottom
https://www.fillernecksupply.com/2-cab-and-chassis-flatbed-fuel-filler-neck-5-8-vent-gas/
Sliders on and uniballs replaced. Rear bumper did not work out and needs some adjustments to the rails that attach to the frame. My 97 that it was built for had to have some extensive work on the ends of the frame, as in they were paper thin where they still existed. We added some box tube to extend them back to factory length and welded the body mounts back on but we didn't quite get them back to OEM specs. They turned out 0.5 inches narrower than what they once were. Now I need to cut off the rails and narrow them 0.25 inches on each side in order to bolt my bumper back on. Not the worst case scenario as I still had my factory bumper to put back on (sorry JC, I was ready to only own one rear bumper).
Sent from my SAMSUNG-SM-G930A using Tapatalk
Sent from my SAMSUNG-SM-G930A using Tapatalk
Drove it to work 
Squishy!
Rising Sun Member
Emissions. She looks goofy but passed!
I daily drove mine, so I put fuel in it, twice.
LARGEONE
Rising Sun Member
The GX 470 got new front rotors and OEM pads this morning. Ready for more sitting in the driveway 
Ah ha! I see it now! I looked at the spacing on the rear tire to the fender, looked at the rims, checked for all kinds of stuff but never looked at the front end. Looks good!Leveling kit.
Sent from my SAMSUNG-SM-G930A using Tapatalk
Thank you, sir!
White Stripe
Hard Core 4+
White Stripe
Hard Core 4+
ccslider
Hard Core 4+
Installed the Dobinsons 3" Tapered lift with 30 mm spacers up front, slee arms due to the tie rod slamming into the stock radius arms. It gave me 5 inches of lift.
The truck is very soft and rides pretty good. I haven't drove too far because my front driveshaft is not happy. I have Boulder Driveline making me a double cardan for the front using a tacoma driveshaft for parts. I also have a part time kit to install but that might not be until winter.
The truck is very soft and rides pretty good. I haven't drove too far because my front driveshaft is not happy. I have Boulder Driveline making me a double cardan for the front using a tacoma driveshaft for parts. I also have a part time kit to install but that might not be until winter.
Attachments
