BritKLR
Vice Commander
The picture was taken after I installed the drone lift system on top. Kinda noisy, but seems to hold the load ok.I think you need a wheel on the other side to help spread out the load
What have you done to your rig today?
- Thread starter HoneyBadger
- Start date
Started the 30K service on my LC-250. Standard array of filters and crap. Need to source differential and transfer case oils to finish up next weekend.
One item of note for 250 owners. Clean out your hybrid battery filters. See page 570 in the owners manual. Mine have been cleaned already decided to replace at this interval.
Part numbers
G92DH-34010
G92DJ-34010
One item I’m pleasantly surprised about is brake pad wear. At this rate I think 100K is realistic out of the stock pads. Considering I’ve got over 12,000 miles of towing in this is impressive.
One item of note for 250 owners. Clean out your hybrid battery filters. See page 570 in the owners manual. Mine have been cleaned already decided to replace at this interval.
Part numbers
G92DH-34010
G92DJ-34010
One item I’m pleasantly surprised about is brake pad wear. At this rate I think 100K is realistic out of the stock pads. Considering I’ve got over 12,000 miles of towing in this is impressive.
Last edited:
Lastresort576
Hard Core 4+
Had some more time today to get the wiring sorted out on my oba setup. Hopefully I’ll get the tank mounted sometime next week. At idle it only builds 120psi, but with the hand throttle set to 1,500rpm it builds to the 146psi shutoff pretty quickly.
—>youtube link of it running.
View: https://youtube.com/shorts/zbk5lUHy7SM?si=xk-fgoOLjZ2-uIjR
—>youtube link of it running.
View: https://youtube.com/shorts/zbk5lUHy7SM?si=xk-fgoOLjZ2-uIjR
I wish I would have ordered that manifold before Joey closed up. I've got the York bracket sitting in the shop. Pulley is already on the crank.
Lastresort576
Hard Core 4+
I just bought it this past October myself. This company on eBay bought the vast majority of his bankruptcy stock.
https://ebay.us/m/RMMIg5
They might have some more for sale still along with other Witsend goodies.
And this is the manifold Joey used with that plate.
unimogguy
Rising Sun Member
- Joined
- May 10, 2022
- Messages
- 308
A 45 parts lot I previously purchased finally got sorted (kinda), spun the 
45 around using Subaru while blocking traffic on the street, PO V-8 engine mounts cut off, almost have the trans stabbed, 3 hinges and license plate holder installed on early FST 40 tailgate thanks @nuclearlemon!!!, mocked up a 25 bezel and aprons to see if I wanted to swap them out for a different look.
45 around using Subaru while blocking traffic on the street, PO V-8 engine mounts cut off, almost have the trans stabbed, 3 hinges and license plate holder installed on early FST 40 tailgate thanks @nuclearlemon!!!, mocked up a 25 bezel and aprons to see if I wanted to swap them out for a different look.Attachments
Last edited:
KC Masterpiece
Hard Core 4+
- Joined
- May 4, 2019
- Messages
- 2,054
Rolled over to 180k.
Lastresort576
Hard Core 4+
Got my Boslla led bulbs installed in the 80 today. Ran into some issues with getting the bulb adapter to lock into place on one housing ..but pretty sure that’s an issue with my bulb socket. Used a little hondabond to lock it in place and we’ll see how it holds.
It’s crazy but I can actually see the road again which is greatly appreciated on these narrow country back roads.
It’s crazy but I can actually see the road again which is greatly appreciated on these narrow country back roads.
dan1554
Rising Sun Member
Weather is getting warmer so I've been able to dedicate more time to not-my-rig, which has a new nickname, 'biohazard'.
Well at least it’s dead. I continue to clean out a nest in my son’s Impresa’s air box every oil change despite the car being daily driven.
CardinalFJ60
Rising Sun Member
You need this stuff!
Contains the finest fox pee money can buy.
Contains the finest fox pee money can buy.
Inukshuk
Rising Sun Member
Yah that stuff has been applied to things that sit. I’m just surprised mice want to continue to nest inside the airbox. Can’t be very pleasant during actual travel. I’ll start the peppermint near the Impreza intake.
dan1554
Rising Sun Member
The rat was a stowaway from Texas and is long, long dead. Mummified, but only after liquifying in to the carpet and one of the setbelts. The owner is planning on having seats reupholstered so Im taking that rear bench seat, aka rats nest, and bagging it up for that guy. The old carpet is pure filth, whats pictured is after it was vacuumed. Might be a good candidate for one of those youtube carpet cleaners.
