FJBen
0
- Joined
- Aug 25, 2005
- Messages
- 892
So my gas gauge reads a little under half when full. Then quickly goes to empty But when I fill up at "E" It's usually 8.5 gallons (i have the 18.5 gallon tank)
Now I'm retarded with the multi-meters...but I think I got it somewhat working. I checked right at the guage and got 32ohms. Which should be right because I'm around less than half a tank. If i hookup all the wires and just put the probe into the connection...I drop to 26ohms...I suspect if I measure the ohms at the gauge they will be very low, thus the gauge reading off meaning my wires are having issues.
It's a 67...i'm sure the wires a poo (as I've already found) so I'm thinking about just running a new wire and a ground up to the gauge....BUT the gauge only works with power to it...so where is it pulling power from to make that guage work? Or how can i rewire to make that gauge work?
Now I'm retarded with the multi-meters...but I think I got it somewhat working. I checked right at the guage and got 32ohms. Which should be right because I'm around less than half a tank. If i hookup all the wires and just put the probe into the connection...I drop to 26ohms...I suspect if I measure the ohms at the gauge they will be very low, thus the gauge reading off meaning my wires are having issues.
It's a 67...i'm sure the wires a poo (as I've already found) so I'm thinking about just running a new wire and a ground up to the gauge....BUT the gauge only works with power to it...so where is it pulling power from to make that guage work? Or how can i rewire to make that gauge work?