It was a 6M zirc and I got it at pep boys. I replaced it with another straight one because I could not find a 90 degree locally
It was a metric set that had several sizes in it
It was a metric set that had several sizes in it
-
NOVEMBER 2025 CLUB MEETING
Hi Guest: The next RS meeting will be Wednesday, Nov. 5, 2025 at 7:30 p.m.
LOCATION: The meeting will be held at Cruisers and Company. Click here for details and directions.
⦿ If you are eligible for club membership, please fill out an application in advance of the meeting and bring it with you.
Zirc fitting
- Thread starter Romer
- Start date
Thanks guys.
Jeff - If I haven't picked up any by the time June rolls around, I'll take you up on your offer. But I suspect I'll need a few spares on hand anyway, as it took no effort at all to snap the first one.....
Jeff - If I haven't picked up any by the time June rolls around, I'll take you up on your offer. But I suspect I'll need a few spares on hand anyway, as it took no effort at all to snap the first one.....
So Ken, did you get the Zirc grease fitting put together so you don't have to pull one end of the drive shaft to lube the u-joint? I just did this last night -- what a PITA.
No, Couldn't find a right angle at the right size and pulled the shaft. Turns out the zirc was plugged so I replaced it. Not sure how much the plugged zirc contributed.
heh, heh.. he pulled the shaft... 
Hey Matt do you have the special needle deal for the DC shaft?
Hey Matt do you have the special needle deal for the DC shaft?
Bump. Needle?