For Sale FZJ80 oil level sensor gaskets

[KC Masterpiece]

Mine has been seeping for several years and I finally want to get it replaced. I was only able to order a set of 10.

They were $1.70 each. If anyone else needs one let me know.

Could maybe pass a few off at the wildflower run to go back to Denver for easy pickup.

 

[Johnny Utah]

Put me down for one please. Thanks Kevin!

 

[DomOfTheDead]

one please!

 

[KC Masterpiece]

one please!

Do you think I could pass them off to you at the wildflower for Denver crew distribution at the next meeting? Even harder for us to get down now that we are in Carbondale.

 

[DomOfTheDead]

Do you think I could pass them off to you at the wildflower for Denver crew distribution at the next meeting? Even harder for us to get down now that we are in Carbondale.

absolutely!

 

[Inukshuk]

PN? Where does this go? Maybe I buy one to help you get rid of them and install as PM?

 

[KC Masterpiece]

PN? Where does this go? Maybe I buy one to help you get rid of them and install as PM?

90430-27001

It goes on the oil level sensor. Driver side below the PHH right near the oil pan if I remember correctly.

Honestly at $1.70 each I dont care about the money. Happy to help some leaky toyotas. If anyone gets one just pass along the parts karma in the future. Ill probably keep 1 as a spare.

 

[DaveInDenver]

Showing location, this for a 1992 FZJ80.

 

[Inukshuk]

cool

Oil Level Gasket Replacement

A simple one bannana fix- Pic#1- I noticed the oil level sensor gasket was leaking. Not dripping but obviously seeping pretty well enough to cake up Pic #2- Simply disconnect sensor wire (press tab on wire side of connector) and 4 10mm bolts I started pulling off the old gasket w/ a...

forum.ih8mud.com

 

[KC Masterpiece]

cool

Oil Level Gasket Replacement

A simple one bannana fix- Pic#1- I noticed the oil level sensor gasket was leaking. Not dripping but obviously seeping pretty well enough to cake up Pic #2- Simply disconnect sensor wire (press tab on wire side of connector) and 4 10mm bolts I started pulling off the old gasket w/ a...

forum.ih8mud.com

I think not breaking that plastic connector is likely the hardest part of the job.