80 acting up since Moab

Hulk

RS Webmaster
Staff member
Cruise Moab Committee
Joined
Aug 22, 2005
Messages
17,374
Location
Centennial
Englewood Driveshaft off South Broadway could do it for you.

It's not that hard to replace a U-Joint -- I did all four in my garage on a Saturday afternoon.
 

Romer

Moderator
Staff member
Joined
Aug 22, 2005
Messages
10,464
Location
Centennial, Colorado
Just go to englewood drive shaft on south Broadway and the will rebuild and balance your drive shaft for about $200 including the U Joints. make sure they use Toyota and have them order from Burt asking for the RS club discount or you could go get them at Stevenson and drop them off. Balancing is important as well.
 

timmbuck2

RS Club TLCA Delegate
Staff member
Cruise Moab Committee
Joined
Oct 5, 2005
Messages
5,298
Location
Denver
Should I replace both the spider and the flange yoke? the flange yoke is what is broken...at Stevinson it is about $120 with RS discount to get just 1 spider and flange yoke...
 

Hulk

RS Webmaster
Staff member
Cruise Moab Committee
Joined
Aug 22, 2005
Messages
17,374
Location
Centennial
Does the spider (Toyota-ese for u-joint) turn freely on all 4 caps? Are the needle bearings all still intact? If it is OK, you could probably re-use it. It is a wear item, so it will eventually need to be replaced, but they do last a long time.
 
Back
Top